Linux version 2.6.25.17 (lentinj@animal) (gcc version 4.1.2) #14 Sun Oct 19 21:59:44 BST 2008 console [early0] enabled CPU revision is: 00029007 (Broadcom BCM3302) ssb: Core 0 found: ChipCommon (cc 0x800, rev 0x05, vendor 0x4243) ssb: Core 1 found: Fast Ethernet (cc 0x806, rev 0x06, vendor 0x4243) ssb: Core 2 found: IPSEC (cc 0x80B, rev 0x01, vendor 0x4243) ssb: Core 3 found: USB 1.1 Hostdev (cc 0x808, rev 0x02, vendor 0x4243) ssb: Core 4 found: PCI (cc 0x804, rev 0x08, vendor 0x4243) ssb: Core 5 found: MIPS 3302 (cc 0x816, rev 0x01, vendor 0x4243) ssb: Core 6 found: MEMC SDRAM (cc 0x80F, rev 0x00, vendor 0x4243) ssb: Initializing MIPS core... ssb: set_irq: core 0x0806, irq 2 => 2 ssb: set_irq: core 0x0804, irq 0 => 3 early_nvram_init: WGT634U NVRAM found. ssb: Sonics Silicon Backplane found at address 0x18000000 Swapping serial ports! Serial init done. Determined physical RAM map: memory: 02000000 @ 00000000 (usable) Entering add_active_range(0, 0, 8192) 0 entries of 256 used Initrd not found or empty - disabling initrd Zone PFN ranges: Normal 0 -> 8192 Movable zone start PFN for each node early_node_map[1] active PFN ranges 0: 0 -> 8192 On node 0 totalpages: 8192 Normal zone: 64 pages used for memmap Normal zone: 0 pages reserved Normal zone: 8128 pages, LIFO batch:0 Movable zone: 0 pages used for memmap Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128 Kernel command line: root=/dev/sda1 usb_storage.delay_use=0 rootdelay=1 console=ttyS0,115200 Primary instruction cache 8kB, VIPT, 2-way, linesize 16 bytes. Primary data cache 4kB, 2-way, VIPT, no aliases, linesize 16 bytes Synthesized clear page handler (26 instructions). Synthesized copy page handler (46 instructions). PID hash table entries: 128 (order: 7, 512 bytes) console handover: boot [early0] -> real [ttyS0] Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 29532k/32768k available (2299k kernel code, 3236k reserved, 369k data, 132k init, 0k highmem) Calibrating delay loop... 198.65 BogoMIPS (lpj=397312) Mount-cache hash table entries: 512 net_namespace: 444 bytes NET: Registered protocol family 16 SCSI subsystem initialized usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb Bluetooth: Core ver 2.11 NET: Registered protocol family 31 Bluetooth: HCI device and connection manager initialized Bluetooth: HCI socket layer initialized Switched to high resolution mode on CPU 0 ssb: PCIcore in host mode found Registering a PCI bus after boot PCI: Fixing up bridge 0000:00:00.0 PCI: Setting latency timer of device 0000:00:00.0 to 64 PCI: Fixing up device 0000:00:00.0 PCI: Fixing latency timer of device 0000:00:00.0 to 168 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered detected lzma initramfs initramfs: LZMA lc=1,lp=2,pb=2,origSize=512 squashfs: version 3.0 (2006/03/15) Phillip Lougher Registering mini_fo version $Id$ io scheduler noop registered io scheduler deadline registered (default) Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing enabled serial8250: ttyS0 at MMIO 0x0 (irq = 3) is a 16550A serial8250: ttyS1 at MMIO 0x0 (irq = 3) is a 16550A serial8250 serial8250.0: unable to register port at index 0 (IO0 MEMb8000400 IRQ3): -28 serial8250 serial8250.0: unable to register port at index 1 (IO0 MEMb8000300 IRQ3): -28 b44.c:v2.0 eth0: Broadcom 44xx/47xx 10/100BaseT Ethernet 00:0f:b5:97:13:64 Driver 'sd' needs updating - please use bus_type methods PCI: Enabling device 0000:00:02.2 (0000 -> 0002) PCI: Fixing up device 0000:00:02.2 ehci_hcd 0000:00:02.2: EHCI Host Controller ehci_hcd 0000:00:02.2: new USB bus registered, assigned bus number 1 ehci_hcd 0000:00:02.2: irq 5, io mem 0x40000000 ehci_hcd 0000:00:02.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected hub 1-0:1.0: over-current change on port 1 Initializing USB Mass Storage driver... usb 1-1: new high speed USB device using ehci_hcd and address 2 usb 1-1: configuration #1 chosen from 1 choice hub 1-1:1.0: USB hub found hub 1-1:1.0: 4 ports detected usb 1-1.3: new high speed USB device using ehci_hcd and address 3 usb 1-1.3: configuration #1 chosen from 1 choice usb 1-1.4: new high speed USB device using ehci_hcd and address 4 usb 1-1.4: configuration #1 chosen from 1 choice hub 1-1.4:1.0: USB hub found hub 1-1.4:1.0: 4 ports detected scsi0 : SCSI emulation for USB Mass Storage devices usb-storage: device found at 3 scsi 0:0:0:0: Direct-Access SanDisk Cruzer 7.01 PQ: 0 ANSI: 0 CCS sd 0:0:0:0: [sda] 7856127 512-byte hardware sectors (4022 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 45 00 00 08 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] 7856127 512-byte hardware sectors (4022 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 45 00 00 08 sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sda2 sda3 sd 0:0:0:0: [sda] Attached SCSI removable disk scsi 0:0:0:1: CD-ROM SanDisk Cruzer 7.01 PQ: 0 ANSI: 0 usb-storage: device scan complete usb 1-1.4.4: new full speed USB device using ehci_hcd and address 5 usb 1-1.4.4: configuration #1 chosen from 1 choice usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usbcore: registered new interface driver usbserial drivers/usb/serial/usb-serial.c: USB Serial support registered for generic usbcore: registered new interface driver usbserial_generic drivers/usb/serial/usb-serial.c: USB Serial Driver core drivers/usb/serial/usb-serial.c: USB Serial support registered for GSM modem (1-port) usbcore: registered new interface driver option drivers/usb/serial/option.c: USB Driver for GSM modems: v0.7.1 Bluetooth: HCI USB driver ver 2.9 usbcore: registered new interface driver hci_usb Registered led device: power TCP vegas registered NET: Registered protocol family 1 NET: Registered protocol family 17 Bluetooth: L2CAP ver 2.9 Bluetooth: L2CAP socket layer initialized Bluetooth: RFCOMM socket layer initialized Bluetooth: RFCOMM TTY layer initialized Bluetooth: RFCOMM ver 1.8 Bluetooth: BNEP (Ethernet Emulation) ver 1.2 Bluetooth: BNEP filters: protocol multicast 802.1Q VLAN Support v1.8 Ben Greear All bugs added by David S. Miller Waiting 1sec before mounting root device... kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 132k freed Algorithmics/MIPS FPU Emulator v1.5 ath_hal: module license 'Proprietary' taints kernel. ath_hal: 2008-09-09 (AR5210, AR5211, AR5212, AR5416, RF5111, RF5112, RF2413, RF5413, RF2133, RF2425, REGOPS_FUNC, DFS, XR) wlan: trunk ath_pci: trunk PCI: Enabling device 0000:00:01.0 (0000 -> 0002) PCI: Fixing up device 0000:00:01.0 Atheros HAL provided by OpenWrt, DD-WRT and MakSat Technologies ath_rate_minstrel: Minstrel automatic rate control algorithm 1.2 (trunk) ath_rate_minstrel: look around rate set to 10% ath_rate_minstrel: EWMA rolloff level set to 75% ath_rate_minstrel: max segment size in the mrr set to 6000 us wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps wifi0: H/W encryption support: WEP AES AES_CCM TKIP ath_pci: wifi0: Atheros 5212: mem=0x40010000, irq=5 Adding 249852k swap on /dev/sda2. Priority:-1 extents:1 across:249852k EXT3 FS on sda1, internal journal kjournald starting. Commit interval 5 seconds EXT3 FS on sda3, internal journal EXT3-fs: mounted filesystem with ordered data mode. b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is off for TX and off for RX. br0: Dropping NETIF_F_UFO since no NETIF_F_HW_CSUM feature. device eth0 entered promiscuous mode device ath0 entered promiscuous mode br0: port 2(ath0) entering learning state br0: port 1(eth0) entering learning state br0: topology change detected, propagating br0: port 2(ath0) entering forwarding state br0: topology change detected, propagating br0: port 1(eth0) entering forwarding state nf_conntrack version 0.5.0 (1024 buckets, 4096 max) ip_tables: (C) 2000-2006 Netfilter Core Team warning: `dnsmasq' uses 32-bit capabilities (legacy support in use) br0: port 2(ath0) entering disabled state br0: port 2(ath0) entering learning state nbd: registered device at major 43 br0: topology change detected, propagating br0: port 2(ath0) entering forwarding state device bnep0 entered promiscuous mode br0: port 3(bnep0) entering learning state br0: topology change detected, propagating br0: port 3(bnep0) entering forwarding state br0: port 3(bnep0) entering disabled state device bnep0 left promiscuous mode br0: port 3(bnep0) entering disabled state